ZIP CUT 28 MITER BANDSAW Bandsaw Operations Manual DA
10 With the blade being held in the guides, loop the blade over the drive wheel and front idle wheels. Apply a slight amount of tension to the blade
11 7. Maintenance and routine adjustments. 7.1 Maintenance Daily: 1. Top off coolant as needed. 2. General cleaning of machine
12 8. Blades: 8.1 Simplified selection chart at right. 1. Rules of thumb for blade selection Four important numbers
13 2. Figure out number of square inches the material is, e.g. 4” x 4” solid = 16 sq inches. 3. Decrease your head feed pressure to ½ of normal c
14 9. Specifications: Capacities: @ 90° 8 ¾” 7 ¾” 10” x 6” @45° 6 ¼” 6” 10 ¼” x 3 1/8” @60° 4” 4”
15 Ref # Dake Part # Ref # Dake Part # 1 010A0009 10 99200010 2 99200002 12 88
16 Ref # Dake Part # Ref # Dake Part # 101 99200101 111 050B0012 102 99200102 113 99200113 103 9
17 Ref # Dake Part # Ref # Dake Part # Ref # Dake Part # 201 99200201 212 99200212 221 992002
18 Ref # Dake Part # Ref # Dake Part # Ref # Dake Part # 230 99200230 239 72212000 248 AF75B148 231 86005005 240 249 AF750148 232 843
19 11. Trouble Shooting:
2 TABLE OF CONTENTS Section
20
21
22 NOTES:
3 MACHINE SET UP / INSTALLATION 1. Machine assembly / set up installation: 1.1 Saw base / pedestal: 1. Remove pre
4 1. Installing machine to base: 1.4 Carefully strap the saw as shown in drawing figure 3. Lift the saw and set carefully onto the base that
5 3. Stock stop installation can be done at any time. This is used to deadhead your material against for cutting repeat lengths. This can be removed
6 C. Blade tensioning handle. Mechanical Blade tensioning handle is turned clockwise To tighten blade; Handle will hit preset bolt At the proper ten
7 H. Guide Arms. The guide arms are horizontally Opposed for great rigidity. The outward arm is Adjustable in and out allowing for close proximity T
8 WARNING: Never let the pull down handle go at the end of the cut. The cutting head is under spring tension and will return upward rapidly and coul
9 2. Remove four knobs that hold blade cover in place. (Figure 9) Hold onto the cover to prevent it from falling. Remove the cover and Set out of y
Commenti su questo manuale