Dake Utility - Bench Manuale Utente

Navigare online o scaricare Manuale Utente per Apparecchiature Dake Utility - Bench. Dake Utility - Bench User Manual [de] Manuale Utente

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 15
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 0
 


BENCH AND FLOOR MODEL PRESSES
10 Ton single acting manual hydraulic press
FOR YOUR OWN SAFETY AND
OPTIMUM OPERATION READ
INSTRUCTION MANUAL BEFORE
OPERATING PRESS
RETAIN THIS MANUAL FOR
FURTHER REFERENCE.
10 TON BENCH PRESS 10 TON FLOOR PRESS
# 972200 #972210
Vedere la pagina 0
1 2 3 4 5 6 ... 14 15

Sommario

Pagina 1 - 

    BENCH AND FLOOR MODEL PRESSES 10 Ton single acting manual hydraulic press FOR YOUR OWN SAFETY AND

Pagina 2

9appropriate tonnage then stop. Release pressure and repeat operation. NOTE: Never pump the ram down fully and dead head the ram in the cylinder.

Pagina 3 - CAUTION

10 7. TROUBLE SHOOTING: Problem Solution Oil leaking around ram. Put ram under full pressure for 24 hours. If problem cont

Pagina 4 - • SAFETY POINTS

11 8. PARTS LIST 10 TON BENCH UTILITY PRESS PARTS LIST Ref # Dake Part # Description Qty. 1 301139

Pagina 5

12 10 TON BENCH UTILITY PRESS

Pagina 6

13 10 TON FLOOR UTILITY PRESS PARTS LIST Ref # Dake Part # Description Qty. 1 301154 Frame upright chan

Pagina 7

14 10 TON FLOOR UTILITY PRESS

Pagina 8

1 TABLE OF CONTENTS • Model specifications page 2 • Placement of press page 2 • Safet

Pagina 9 - 5. OPERATION (PROCEDURE)

2 SPECIFICATIONS Machine Specifications: 10 TON UTILITY BENCH 10 TON UTILITY FLOOR Press Type Manual 10 ton B

Pagina 10 - MAINTENANCE!

3 1. Keep hands out of point of operation. 2. Never hold part while pressing. 3. Always wear the eye protection. 4. Clamp work piece or brace w

Pagina 11

43. WARNING LABELS: READ AND UNDERSTAND THESE WARNING LABELS PLACED ON THIS MACHINE BEFORE OPERATING. MAKE SURE ALL PERSONS IN THE AREA OF THE PRE

Pagina 12

54. ASSEMBLY INSTRUCTIONS: FOR DAKE MODEL UTILITY 10 TON BENCH AND FLOOR MODEL PRESSES. Your new Dake Press has been packaged in

Pagina 13

6STEP 2. Floor model: (Bench model skip this step) Install the diagonal support straps. Using 4 M8 x 25mm bolts, nuts and washers. Install the supp

Pagina 14

7STEP 6: With press standing upright and all bolts tightened install the worktable. Insert two table pins in the two lowest holes. Take the worktab

Pagina 15 - 10 TON FLOOR UTILITY PRESS

8 Nose piece Table block NOTE: System is filled with oil and may take a few pumps to fill all lines.

Modelli collegati Utility - Floor

Commenti su questo manuale

Nessun commento